Gilba SolutionsIndependent turf agronomy · Bowral NSW

Gilba Solutions Pty Ltd · consulting since 2013

Independent turf agronomy for sportsgrounds, golf courses and councils

Gilba Solutions is a Bowral-based consultancy that measures what is happening in your soil, water and turf before recommending anything. Site work covers New South Wales, the ACT and Queensland.

Book a free consultation See how sites are assessed

2013year the consultancy began

35+years of turf experience behind the advice

NSW · ACT · QLDwhere site work is carried out

1 business dayto hear back after you get in touch

Advice built on measurement, not guesswork

Gilba Solutions has worked as an independent sports turf consultancy since 2013, from a base in Bowral in the Southern Highlands, between Sydney and Canberra. The approach is simple: test the surface, the soil and the water first, then recommend only what the results support. Programs are shaped around the budget a council, school or club really has, and most new work arrives through repeat clients and referrals.

The team includes a university-qualified soil scientist, and Gilba has been an early adopter of field tools such as NDVI imaging, soil moisture mapping and GPS-referenced compaction mapping.

Seven ways a turf surface gets measured

Recommendations follow one of these assessments, a soil or water test, or a site visit.

01

Sports turf health assessment

A full audit of the playing surface. The surface is mapped and measured, turf health is put into numbers, and problems with compaction, drainage, soil, safety or grass selection are flagged. You receive a plain-English report with practical recommendations, aimed at keeping chemical, fertiliser and water use in check.

02

Surface hardness testing

A cone penetrometer reads hardness at the surface and further down the profile, showing where compaction is building up and where the surface may be a safety concern for players.

03

NDVI turf health imaging

NDVI imaging shows how vigorous the turf is across the whole site. It helps pick up disease, wear and shade stress, sometimes before the damage is obvious from the ground.

04

Soil moisture mapping

Moisture readings are mapped across the surface so dry and wet zones are clear. The map is also the starting point for an irrigation audit.

05

Shade analysis

A site visit to work out where shade is holding the turf back, and which remedies are realistic for that venue.

06

Soil testing

Laboratory reporting on the physical and chemical make-up of the root zone. For golf and bowling greens, Gilba's free organic matter calculator projects organic matter by depth from loss-on-ignition results.

07

Water testing

Irrigation water chemistry can change soil chemistry and structure, and can speed up the alkaline breakdown of some turf chemicals. A water test shows whether your supply is part of the problem.

Read the full agronomic services page on gilbasolutions.com

Getting a soil test worth acting on

A soil test is only as good as the sample and the person reading it. These are the checks Gilba suggests before sending anything to a laboratory:

  1. Test at the right interval. Heavy soils rarely need testing every year. A new sand construction benefits from regular testing, and most other sites are fine every three years unless there is a specific problem or a sand-based root zone.
  2. Make the sample representative. Take cores from across the area, not from one convenient spot.
  3. Record the last fertiliser. Note when it went out, because a recent application changes the numbers.
  4. Know the extraction method. Laboratories use different methods, and results are not always comparable between them.
  5. Know who is interpreting it. The same report can lead to very different programs depending on who reads it.

For golf and bowling greens, try Gilba's free putting green organic matter calculator.

How many hours a week can a ground take?

Too many hours of play is a frequent cause of winter damage. In one Gilba case study, a Sydney private school oval taking more than 70 hours of use a week had compaction building up at 100 mm. Gilba's guidance puts typical weekly capacity at:

By construction type
ConstructionHours per week
Soil field, with or without drains2 to 3.7
Sand profile with drains5.3 to 11
Sand carpet construction12 to 13
By season and grass
SeasonPerennial ryegrassCouch
Winter5 to 1215 to 20
Summer10 to 1520 to 25

Real capacity also depends on player age (adults cause more wear), turf type, time of year, drainage and irrigation. Spreading wear away from training hot spots and repairing damage straight after games both help a ground last the season.

Jerry Spencer, principal agronomist

Jerry Spencer started Gilba Solutions in 2013 and is its principal agronomist. He holds a BSc (Hons) in Soil Science from the University of Newcastle, worked as an agronomist with the Sports Turf Research Institute (STRI) in the UK, and has more than 35 years in sports turf, golf and stadium work across Australia, New Zealand, the UK and Europe.

He is the author of Nutrition of Sports Turf in Australia and The Definitive Guide to Australian Turfgrass Pesticide Management.

Jerry Spencer's profile on gilbasolutions.com

Clients and government panels

Gilba's clients have included the NRL, Sydney University, the ACT Government, Campbelltown and Liverpool councils, Canberra Stadium, the Australian Institute of Sport, Knox Grammar and The King's School, as well as golf clubs such as Federal and Twin Creeks.

  • Member of the NSW Local Government Procurement Panel since 2020
  • Appointed to the ACT Government seed panel in 2021

Book a free consultation

Talk through your ground, course or green with Jerry. There is no cost or obligation for the first conversation.

Gilba Solutions Pty Ltd
21 Thompson Street, Bowral NSW 2576
Phone: 04999 75819
Email: jerry@gilbasolutions.com
Hours: Monday to Friday, 8am to 5pm
Web: gilbasolutions.com

Call 04999 75819